Views: 9 Author: Site Editor Publish Time: 2019-07-08 Origin: Site
Five points to be aware of when gypsum cornice machine are installed in winter
We know that the gypsum lines produced by the gypsum line machine are practical and beautiful, low in price, have fireproof, moisture-proof, heat-insulating, sound-insulating, heat-insulating functions, and can play a luxurious decorative effect, and are generally used as interior decoration as a corner line. The five points that the plaster line needs to pay attention to when installing in winter, let's take a look.
1.Gypsum line avoids loosening and loosening: the plaster line is kept at a distance of 0.5 cm from the top surface and the wall surface to avoid cracking of the plaster line. The gypsum powder and latex can be used for joint filling. In addition, when making gypsum ceilings, the internal wooden keel must be kept dry, and must be firm, and there should be no looseness, otherwise it will be prone to cracks in the gypsum board ceiling.
2,select the time to brush the wall: the best time to brush the wall in winter is between 10 am and 4 pm. This period of time is relatively high, which can prevent the putty from freezing. In addition, due to the low outdoor temperature in winter, tiles can not be laid immediately from the outside into the house, and should be kept for at least 24 hours, so that the tiles can be adapted to the indoor temperature before being laid.
3,to prevent material deterioration and deformation: the veneer should be laid flat, the bottom of the bottom of a large core board, a large core board pressed above, can not be placed, so that the panel can be prevented from cracking and lifting. Do not stack the decorative materials such as plates and paints on the side of the heating to avoid deformation due to heat, which makes the construction difficult to carry out normally.
4,coating application temperature is higher than 5 ° C: Because the ambient temperature of the coating application should not be lower than 5 ° C, therefore, in winter decoration construction should pay attention to close the doors and windows, to ensure that the indoor temperature is at least 5 ° C. On the one hand, the indoor temperature can be ensured, on the other hand, the outdoor wind and sand can be prevented from being blown to the unfinished furniture and the wall surface, and the phenomenon of roughness and roughness is caused, and the door and window should be opened and ventilated after the paint is sufficiently dried.
5,the putty is even thin and thick: the indoor air is dry, the water loss is faster, if the putty is too thick, it will cause empty drum, cracking, wall inequality.
Drying in the winter, especially when installing the plaster line at this time, we must pay attention to the above mentioned points.we are provide gypsum cornice machine brands,you can know it.
Customer for the purpose, to satisfy every customer's pre-sales and after-sales service needs
Market-oriented, seeking and respecting every reality and potential customer
Factory management as the core, increase sales and market share and coverage
The new development is based on the standardization, serialization of the perfect design, product technology and continuous innovation.
